Skip to content

Maritime Knowledge Base

Browse questions and answers across marine machinery, merchant navy careers, shipboard operations and maritime glossary terms.

Browse by Category

Results for "Cylinder oil"

Shipboard Operations

What should be checked during engine-room watchkeeping rounds?

An engine-room round compares readings, sounds and smells with normal values for the current load, logs real figures and spots trends before alarms do.

Marine Machinery

Why won't my marine air compressor build pressure?

A compressor that runs but won't fill the receiver usually has leaking valves. Next check the unloader, drains, leaks, cooling, intake filter and piston rings.

Marine Machinery

What causes a scavenge fire in a two-stroke marine engine?

A scavenge fire starts when oil and carbon in a two-stroke engine's scavenge space are ignited, usually by hot gas blowing past worn or stuck piston rings.

Marine Machinery

What causes a crankcase explosion in a marine engine?

A crankcase explosion happens when a hot spot turns lubricating oil into a fine mist that ignites. Mist detection and a prompt stop are the main defences.

Marine Machinery

Why won't the main engine start on air?

A main engine that won't start on air usually has a starting air fault, a fuel problem or a blocking interlock such as the turning gear or an unreset shutdown.

Marine Machinery

What causes a marine engine turbocharger to surge?

Turbocharger surging is a brief reversal of airflow in the compressor, usually caused by fouling in the air or gas path or by sudden changes in engine load.

Marine Machinery

How does a marine diesel engine work?

A marine diesel engine ignites fuel by compressing air until it is hot enough to burn it. How the two-stroke and four-stroke engines used at sea differ.

Marine Machinery

What is the difference between a two-stroke and a four-stroke marine engine?

A two-stroke fires every revolution and a four-stroke every second revolution. Big ships use slow two-strokes for propulsion and four-strokes for generators.

Marine Machinery

How does a marine engine turbocharger work?

A turbocharger uses exhaust gas to spin a turbine that drives a compressor, pushing extra air into the cylinders so the engine can burn more fuel.

Marine Machinery

How does a marine air compressor work and why is it needed?

A marine air compressor compresses air in two stages with cooling between them, filling receivers to about 30 bar, mainly to start the ship's diesel engines.

Marine Machinery

What is cylinder lubrication in a two-stroke marine engine?

Cylinder lubrication is the separate oil supply fed onto the liner of large two-stroke engines to lubricate, neutralise fuel acids and keep the surfaces clean.

Marine Machinery

How does a ship's steering gear work?

Steering gear turns the rudder on orders from the bridge, using hydraulic rams or rotary vanes driven by pumps, with SOLAS setting rudder times and backup.

Marine Machinery

What is jacket cooling water in a marine engine?

Jacket cooling water is treated fresh water pumped around a diesel engine's cylinder liners, heads and exhaust valves to remove heat at a steady temperature.

Shipboard Operations

How does a fixed CO2 flooding fire-extinguishing system work?

A fixed CO2 system floods a sealed, evacuated space such as an engine room with carbon dioxide, cutting the oxygen until the fire can no longer burn.

Marine Machinery

What is scavenging in a two-stroke marine engine?

Scavenging is how a two-stroke engine clears exhaust gas from the cylinder and refills it with fresh air near bottom dead centre, before the next compression.

Marine Machinery

How does a ship's fuel oil system store, clean, heat and deliver fuel to the engines?

Fuel goes from bunker tanks to a settling tank, through centrifugal separators to the service tank, then is heated to the right viscosity and pumped to engines.